An electric roller shutter gate is usually the electric door of a shop or mall. It is a series of jointed doors linked in a chain, rotating around a fixed shaft above the door. So how do you install it? The pro installers at RHidoor share their method.
- First, an RHidoor engineer visits at the agreed time to survey the site for free, confirm the size, install method, and your requirements, then build a quality roller gate so you use it happily and with peace of mind.
- RHidoor’s delivery team brings the gate and a pro installer to the site. Before work, ready the tools: welder, electric hammer, hand drill, ladder, drill bits, cutting head, level, screwdrivers, and accessories.
- Based on the site, mark a line 50 cm above the side-plate opening. Use a level to mark a vertical line 13 cm from the opening, then a vertical line 9 cm from the auxiliary plate on the frame. Fix the side plate on the vertical line, and mark a horizontal line at its highest point.
- Test the handle. Fix the motor to the main board, link the wheel to the motor base with a chain, and connect the remote box to the motor. Check if the handle is reversed; if the remote receiver is upside down, pull the built-in black button.
- Weld the electric roller shutter firmly. After setting the right size, weld it solidly to the shaft so the drill can bore vertically and store. Check the power works. Pull the track into a saw-tooth shape, level the shutter, confirm the upper and lower lines are right, then raise it with the screw.
- Check and test. After power on, pull the switch to do a lift demo, make sure no fault. Confirm the track is smooth and clean and the button does not bounce or fail.